Technical data

Cisco SM-X Layer 2/3 EtherSwitch Service Module Configuration Guide for Cisco 4451-X ISR
Troubleshooting the Cisco SM-X Layer 2/3 ESM Software
29
Cisco SM-X Layer 2/3 EtherSwitch Service Module Configuration Guide for Cisco 4451-X ISR
Step 9
copy flash:
Example:
Switch# copy flash:config.text
system:running-config
Copies the configuration file into memory.
Step 10
configure terminal
Example:
Switch# configure terminal
Enters global configuration mode.
Step 11
enable secret password
Example:
Switch(config)# enable secret 5
$1$LiBw$0Xc1wyT.PXPkuhFwqyhVi0
Sets the password.
• The secret password can be from 1 to 25
alphanumeric characters.
• It can start with a number.
• It is case sensitive.
• It allows spaces but ignores leading spaces.
Step 12
exit
Example:
switch(config)# exit
Returns you to privileged EXEC mode.
Step 13
copy running-configuration startup-configuration
Example:
switch# copy running-config startup-config
Copies the configuration from the running
configuration file to the switch startup configuration
file.
• This procedure is likely to leave your Cisco
enhanced EtherSwitch service module virtual
interface in a shut down state.
• You can see which interface is in this state by
entering the show running-configuration
privileged EXEC command.
• To reenable the interface, enter the interface vlan
vlan-id global configuration command, and
specify the VLAN ID of the shut down interface.
With the Cisco enhanced EtherSwitch service
module in interface configuration mode, enter the
no shutdown command.
Step 14
hw-module subslot 1/0 reload force
Example:
Router# hw-module reload
Reloads and restarts the ESM. The “force” option
allows you to proceed without prompting you for
confirmation.
Command or Action Purpose