Technical data

Cisco SM-X Layer 2/3 EtherSwitch Service Module Configuration Guide for Cisco 4451-X ISR
Upgrading the Cisco SM-X Layer 2/3 ESM Software
17
Cisco SM-X Layer 2/3 EtherSwitch Service Module Configuration Guide for Cisco 4451-X ISR
The following example shows power consumed by various devices connected to your module:
Switch# show power inline
Available:500.0(w) Used:24.0(w) Remaining:476.0(w)
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Gi0/1 auto off 0.0 n/a n/a 30.0
Gi0/2 auto on 12.0 IP Phone [phone]
Gi0/3 auto on 12.0 IP Phone [phone]
Gi0/4 auto off 0.0 n/a n/a 30.0
Gi0/5 auto off 0.0 n/a n/a 30.0
Switch# show power inline police
Available:623(w) Used:6(w) Remaining:617(w)
Interface Admin Oper Admin Oper Cutoff Oper
State State Police Police Power Power
--------- ------ ---------- ---------- ---------- ------ -----
Gi0/1 auto off none n/a n/a 0.0
Gi0/2 auto on none n/a n/a 16.7
Gi0/3 auto off errdisable n/a 0.0 0.0
Gi0/4 auto on errdisable ok 16.6 11.4
Gi0/5 auto on log ok 16.6 11.2
Gi0/6 auto on errdisable overdrawn 0.0 0.0
The following table lists the interface and the status.The following example shows the power usage when
PDs (powered devices) are connected to your module:
Switch# show cdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone,
D - Remote, C - CVTA, M - Two-port Mac Relay
Device ID Local Intrfce Holdtme Capability Platform Port ID
ISR 4451-X Gig 0/26 150 R ISR4451-X BDI1
ISR 4451-X Gig 0/26 172 R ISR4451-X Eth 1/0/0
SEPE80462EB2EA7 Gig 0/2 155 H P M IP Phone Port 1
SEPACA0166EFD07 Gig 0/3 163 H P M IP Phone Port 1
Upgrading the Cisco SM-X Layer 2/3 ESM Software
This section describes how to upgrade the Cisco SM-X Layer 2/3 ESM software by using TFTP.
You can copy the switch image to the ESM flash by following one of the two methods listed below:
• Establish connectivity from your ESM’s front panel port to the TFTP server where the desired
switch Cisco.com image is stored
• Copy the switch image (available on Cisco.com) to the router’s flash and copy this image to ESM
flash through TFTP.
Copying Switch Image Directly to ESM Flash Through TFTP Server
This section describes how to copy a switch image directly to the ESM flash through the TFTP server.