Technical data

Cisco SM-X Layer 2/3 EtherSwitch Service Module Configuration Guide for Cisco 4451-X ISR
How to Configure the Cisco SM-X Layer 2/3 ESM on the Router
16
Cisco SM-X Layer 2/3 EtherSwitch Service Module Configuration Guide for Cisco 4451-X ISR
DETAILED STEPS
Example
The following example displays the maximum power configured:
Router# show power inline
Available:500.0(w) Used:24.0(w) Remaining:476.0(w)
Interface Admin Oper Power Device Class Max
(Watts)
--------- ------ ---------- ------- ------------------- ----- ----
Et1/0/0 auto off 24.0 n/a n/a 750.0
Et2/0/0 auto off 0.0 n/a n/a 750.0
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enters privileged EXEC mode.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface gigabitethernet slot/port
Example:
Router(config)# interface gigabitethernet 0/24
Enter interface configuration mode and places you at
the GigabitEthernet 0/24 interface.
Step 4
power inline max max-wattage
Example:
Router(config-if)# power inline max 4000
Specifies the cut off power value for a port.
• max max-wattage—Limits the power allowed on
the port. The range is 4000 to 30000 mW. If no
value is specified, the maximum is allowed.
Step 5
power inline police action action
Example:
Router(config-if)# power inline police action log
Enables the ESM to generate a syslog message while
still providing power to the device.
• action action— Specifies an action. For
example, a log message or a warning message to
avoid flooding of event log or even shutting
down the port.
Step 6
exit
Example:
Router(config-if)# exit
Exits the interface configuration mode.