Specifications

Installation and Configuration

Collecting Required Tools and Information

Cisco 4400 Series Wireless LAN Controllers - Installation and Configuration Guide

78-17157-01

–

VLAN identifier, if the management interface is assigned to a VLAN, or ‘0’ for an untagged

VLAN.

–

Distribution System Physical Port number:

* 4402: 1 - 2 for front panel GigE ports

* 4404: 1 - 4 for front panel GigE ports

–

IP address of the default DHCP server that will supply IP addresses to clients.

–

LWAPP Transport Mode, LAYER2 or LAYER3.

• Virtual Gateway IP address: one fictitious, unassigned IP address (such as 1.1.1.1) to be used by all

Cisco Wireless LAN Controller Layer 3 Security and Mobility managers.

• Cisco Wireless LAN Controller Mobility Group (RF Group) Name, if required.

• 802.11 Network Name (SSID) for WLAN 1. This is the default SSID that the access points use when

they join with the Cisco Wireless LAN Controller.

• Whether or not to allow static IP addresses for clients.

* Yes = more convenient, but lower security (session can be hijacked), clients can supply their own

IP address, better for devices that cannot use DHCP.

* No = less convenient, higher security, clients must use DHCP for an IP address, works well for

Windows XP devices.

• When you are configuring a RADIUS server, the server IP address, communication port, and Secret.

• Country Code for this installation. Refer to Configuring the Cisco Wireless LAN Controller and

Cisco WLAN Solution Supported Country Codes in the Product Guide.

• 802.11b network enabled or disabled?

• 802.11a network enabled or disabled?

• 802.11g network enabled or disabled?

• Radio Resource Management (RRM) (Auto-RF) enabled or disabled?

Continue with “Determining a Physical Location.”