Specifications

VIEW Configuration Guide: Cisco WLAN Controllers (Virtual, Modules, and Standalone) with APs
1725-86192-000_AA.docx
August 2013 58
2 In the navigation pane, under Access Points click Radios, then select 802.11a /n. All the
APs that are connected should be listed, showing their Operational Status as UP.
3 Select Configure from the drop-down list for the access point you wish to change. Set
the parameters for that AP:
Settings: Power and channel settings
Global settings for RF Channel Assignment and Tx Power Level Assignment were
not tested. For Custom Tx Power and RF Channel settings please consult your
facility’s RF site survey — optimized for wireless voice traffic — to determine correct
power and channel settings for each AP using non-overlapping channels.
a Set Admin Status to Enable.
b Configure any other settings that might be relevant to your deployment as needed.
c Click the Apply button to save all changes.
Screenshot for access points with internal antennas: