Specifications

VIEW Configuration Guide: Cisco WLAN Controllers (Virtual, Modules, and Standalone) with APs
1725-86192-000_AA.docx
August 2013 53
AP Configuration
Settings: QoS setting
All handsets operating on a given AP radio must have the same QoS setting. All APs
supporting the handsets must be configured to enable the corresponding features.
1 Power-on and connect the APs to the network. Wait a few minutes for the APs to find the
controller.
2 Verify the APs are associated to the WLC.
3 From the main menu, click Monitor.
Configuration for handsets running in 802.11b & b/g mixed and g only mode
Admin Tip: When to use g-only
When 8020/8030 handsets are set to g only mode, they support the higher g data
rates. In g only mode, however, the handset will not detect 802.11b clients and will
not provide protection. G only mode in these handsets should be used only if there is
no possibility of an 802.11b client or the network will experience data corruption.
1 From the main menu, click Wireless.
2 In the navigation pane, under Access Points click Radios, then select 802.11b/g/n. All
the APs that are connected should be listed, showing their Operational Status as UP.