Specifications

VIEW Configuration Guide: Cisco WLAN Controllers (Virtual, Modules, and Standalone) with APs
1725-86192-000_AA.docx
August 2013 27
b Enter the commands:
config 802.11b 11nsupport a-msdu tx priority all disable
save config
3 If an 1142 ap is in use, disable mpdu aggregation.
a Connect to the CLI as described in the section “Configuring a New Controller Starting
from Factory Defaults”.
b Enter the commands:
config 802.11b 11nsupport a-mpdu tx priority all disable
save config
4 Click the Apply button to save the settings.
5 In the navigation pane under 802.11b/g/n, select Network.
6 For 802.11b/g Network Status, click the Enabled check box.
Configuration for handsets running in 802.11a mode in the 8020/8030 handsets and using the 5
GHz radio in the 84-Series handsets
1 From the main menu, click Wireless.
2 In the navigation pane, under Access Points click Radios, then select 802.11a /n. All the
APs that are connected should be listed, showing their Operational Status as UP.
3 Select Configure from the drop-down list for the access point you wish to change. Set
the parameters for that AP: