Installation guide

3-33

Catalyst 3750 Switch Hardware Installation Guide

78-15136-02

Chapter 3 Switch Installation

Installing the Switch

Attaching the RPS Connector Cover

If you are not using an RPS with your switch, use the two Phillips pan-head

screws to attach the RPS connector cover to the back of the switch, as shown in

Figure 3-31 and Figure 3-32.

Warning

If an RPS is not connected to the switch, install an RPS connector cover on the

back of the switch.

Figure 3-31 Attaching the RPS Connector Cover on the Catalyst 3750G-24TS Switch

1 Phillips pan-head screws 3 RPS connector

2 RPS connector cover

CONSOLE

STACK 1

STACK 2

C INPUTS FOR R

EMOTE

POW

SUPPLY

SPECIFIED IN M

ANUAL

+12v @

8.5a

21 3

86571