Installation guide

Chapter 3 Switch Installation

Connecting to an SFP Module

3-46

Catalyst 3750 Switch Hardware Installation Guide

78-15136-02

might not be turned on, or there might be a cable problem or a problem with the

adapter installed in the attached device. See Chapter 4, “Troubleshooting,” for

solutions to cabling problems.

Step 3 Reconfigure and reboot the connected device if necessary.

Step 4 Repeat Steps 1 through 3 to connect each device.

Figure 3-40 Connecting to an Ethernet Port

Connecting to an SFP Module

This section describes how to connect to SFP modules. For instructions on how

to connect to fiber-optic SFP modules, see the “Connecting to 1000BASE-T SFP

Modules” section. For instructions on how to connect to 1000BASE-T SFP

modules, see the “Connecting to 1000BASE-T SFP Modules” section.

For instructions about how to install or remove an SFP module, see the “Installing

and Removing SFP Modules” section on page 3-40.

SYST

RPS

MASTR

STAT

DUPLX

SPEED

STACK

MODE

11X

12X

86818