Installation guide

Chapter 2 Switch Installation
Installing the Switch
2-32
Catalyst 3750 Switch Hardware Installation Guide
OL-6336-01
Attaching the RPS Connector Cover
If you are not using an RPS with your switch, use the two Phillips pan-head
screws to attach the RPS connector cover to the back of the switch, as shown in
Figure 2-31.
Warning If an RPS is not connected to the switch, install an RPS connector cover on the
back of the switch.
Figure 2-31 Attaching the RPS Connector Cover on the Catalyst 3750 Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached
securely to wall studs or to a firmly attached plywood mounting backboard.
Mount the switch with the front panel facing up, as shown in Figure 2-32.
Warning To comply with safety regulations, mount the switches on a wall with the front
panel facing up.
1 Phillips pan-head screws 3 RPS connector
2 RPS connector cover
CONSOLE
STACK 1
STACK 2
DC INPUTS FO
R REMOTE
PO
W
ER
SUPPLY
SPECIFIED IN MANUAL
+12v @
8.5a
21 3
86571