Installation guide

Chapter 2 Switch Installation
Installing the Switch
2-16
Catalyst 3750 Switch Hardware Installation Guide
OL-6336-01
Installing the Switch
This section describes these installation procedures:
• Rack-Mounting, page 2-16
• Wall-Mounting, page 2-31
• Table- or Shelf-Mounting, page 2-34
Rack-Mounting
To install the switch in a 19-inch or 24-inch rack (24-inch racks require optional
mounting hardware), follow the instructions described in these procedures:
• Removing Screws from the Switch, page 2-17
• Attaching Brackets to the Catalyst 3750G-24TS Switch, page 2-19
• Attaching Brackets to the Catalyst 3750-24TS, 3750G-24TS-1U,
3750G-24T, 3750G-12S, 3750-24PS, 3750G-24PS, 3750-48PS,
3750G-48PS, 3750G-16TD, 3750-48TS, and 3750G-48TS Switches,
page 2-24
• Mounting the Switch in a Rack, page 2-27
• Attaching the Cable Guide, page 2-29
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you
must take special precautions to ensure that the system remains stable. The
following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the
top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the unit in the rack.
Statement 1006