Installation guide

Chapter 2 Switch Installation

Installing and Removing XENPAK Modules

2-46

Catalyst 3750 Switch Hardware Installation Guide

OL-6336-01

Figure 2-41 Installing a XENPAK Module in the Catalyst 3750G-16TD Switch

Step 6 Secure the XENPAK module in place by tightening the two captive installation

screws. Do not overtighten the captive screws.

Removing a XENPAK Module

To remove a XENPAK module, follow these steps:

Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on

the chassis.

Step 2 Disconnect the cable from the XENPAK module. For fiber-optic modules, install

the optical bore dust plugs.

Step 3 Loosen the two captive installation screws that secure the XENPAK module in the

slot.

Step 4 Carefully pull on the two captive installation screws to disconnect the XENPAK

module from the slot.

1 Optical bore dust plug 2 Captive installation screw

Catalyst 3750

series

104573