Installation guide

Chapter 2 Switch Installation

Installing and Removing XENPAK Modules

2-42

Catalyst 3750 Switch Hardware Installation Guide

OL-6336-01

Figure 2-38 Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver

Step 4

Grasp the SFP module between your thumb and index finger, and carefully

remove it from the module slot.

Step 5 For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP

module to keep the optical interfaces clean.

Step 6 Place the removed SFP module in an antistatic bag or other protective

environment.

Installing and Removing XENPAK Modules

These sections describe how to install and remove XENPAK modules. XENPAK

modules are inserted into the XENPAK module slot on the front panel of the

Catalyst 3750G-16TD switch. These field-replaceable transceiver modules

provide 10-Gigabit interfaces.

Note The 10-Gigabit Ethernet XENPAK modules are referred to as 10-Gigabit Ethernet

module ports in the switch software documentation.

1 Bale clasp

Catalyst 3750

SERIES

13X

14X

23X

24X

86554