Specifications
Table Of Contents
- Software Configuration Guide
- Contents
- Preface
- Understanding Interface Numbering and Cisco IOS Software Basics
- Understanding Interface Numbering
- Understanding Cisco IOS Software Basics
- Upgrading to a New Cisco IOS Release
- Where to Go Next
- Using the Setup Command Facility
- Before Starting Your Router
- Using the setup Command Facility
- Configuring Global Parameters
- Configuring Interface Parameters
- Completing the Configuration
- Where to Go Next
- Configuring with the Command-Line Interface
- Configuring the Host Name and Password
- Configuring 1-Port and 2-Port Ethernet Interfaces
- Configuring Fast Ethernet Interfaces
- Configuring Asynchronous/Synchronous Serial Network Modules or WAN Interface Cards
- Configuring 16-Port and 32-Port Asynchronous Network Modules
- Configuring ISDN BRI WAN Interface Cards
- Configuring T1 and E1 Interfaces
- Configuring T1 (FT1) WAN Interface Cards
- Configuring ATM Interfaces
- Configuring Inverse Multiplexing for ATM Interfaces
- Configuring Analog Modem Interfaces
- Configuring Wireless Multipoint Interfaces
- Checking the Interface Configuration
- Configuring 1-Port ADSL WAN Interface Card
- Configuring the NM-AIC-64, Contact Closure Network Module
- Configuring the 1-Port HSSI Network Module
- Configuring the Compression Network Module for the Cisco 3600 Series Routers
- Configuring the Digital Modem Network Module for the Cisco 3640 Router
- Prerequisites
- Configuration Tasks
- Configure the E1/T1 Network Module for ISDN PRI
- Configure the ISDN D-Channel Serial Interfaces
- Configure the Loopback Interface
- Configure the LAN Interface
- Create the Group Asynchronous Interface
- Configure the ISDN Dialer Interface
- Configure the Default IP Pool Information
- Configure Modem Lines for Dial-In and Dial-Out
- Configuration Example
- Configuring 1-Port G.SHDSL WAN Interface Card
- Saving Configuration Changes
- Where to Go Next
- Configuring Voice-over-IP
- Voice-over-IP Prerequisites
- Configuring the Voice Interface
- Voice-over-IP Configuration Examples
- Where to Go Next
- Configuration Examples
- Cisco 2600 Series Router Configuration Example
- Cisco 3631 Router Configuration Example
- Cisco 3725 Router Configuration Example
- 1-Port ADSL WAN Interface Card Configuration Examples
- NM-AIC-64, Contact Closure NetworkConfiguration Examples
- Cisco 3640 Central Site Configuration to Support ISDN and Modem Calls
- Formatting the Compact Flash Memory Cards
- Using the ROM Monitor
- Index
Contents
v
Software Configuration Guide For Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
OL-1957-03
CHAPTER
3 Configuring with the Command-Line Interface 3-1
Configuring the Host Name and Password 3-2
Verifying the Host Name and Password 3-3
Configuring 1-Port and 2-Port Ethernet Interfaces 3-3
Configuring Fast Ethernet Interfaces 3-4
Configuring Asynchronous/Synchronous Serial Network Modules or WAN Interface Cards 3-5
Configuring 16-Port and 32-Port Asynchronous Network Modules 3-9
Configuring ISDN BRI WAN Interface Cards 3-10
Configuring ISDN BRI Lines 3-12
ISDN BRI Provisioning by Switch Type 3-13
Defining ISDN Service Profile Identifiers 3-14
Configuring T1 and E1 Interfaces 3-15
Configuring T1 Interfaces 3-15
Configuring E1 Interfaces 3-16
Configuring TDM Connect (Data Pass-Through) 3-17
Configuring Codec Complexity 3-18
Configuring T1 (FT1) WAN Interface Cards 3-19
Default Configuration 3-19
Configuring ATM Interfaces 3-20
Configuring PVCs 3-21
Configuring SVCs 3-22
Configuring Inverse Multiplexing for ATM Interfaces 3-23
Configuring the ATM T1/E1 Interface 3-23
Configuring the IMA Interface 3-25
Checking the IMA Configuration 3-26
Configuring Analog Modem Interfaces 3-26
Checking the Modem Configuration 3-28
Configuring Wireless Multipoint Interfaces 3-29
Checking the Interface Configuration 3-29
Configuring 1-Port ADSL WAN Interface Card 3-29
Benefits 3-30
Restrictions 3-30
Prerequisites 3-31
Configuration Tasks 3-31
Configuring the ADSL Port on the ADSL WAN Interface Card 3-31
Verifying ATM Configuration 3-32
Configuration Examples 3-34
Configuring the NM-AIC-64, Contact Closure Network Module 3-34