Specifications

3-40
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
OL-1957-03
Chapter 3 Configuring with the Command-Line Interface
Configuring the NM-AIC-64, Contact Closure Network Module
Accessing the AIC
Remote-CLI and local-CLI are the two methods for accessing the AIC:
• Remote-CLI involves telneting to the IP address of the AIC. For example:
telnet 10.5.5.2
• Local-CLI involves accessing the asynchronous craft port by telneting to the IP address of the router
and the AIC’s TCP port number. For example:
telnet 10.2.130.105 2001
where 10.2.130.105 is the router’s IP address and 2001 is on slot 0 of the AIC.
The AIC’s TCP port number depends on the slot number in which the AIC is installed. As shown in
Table 3-12, the Cisco IOS software reserves the first line of each slot for the asynchronous craft port.
Configuring the NOC IP Address
Configure up to four NOC IP addresses to which the AIC will send SNMP messages, beginning in global
configuration mode:
Note The aic command-line prompt indicates that either TL1 or AIC CLI commands must be used.
Table 3-12 TCP Port Number Allocation for the AIC on the Cisco 2600 and Cisco 3600 Series
Slot Number Terminal Line Number for the AIC’s Asynchronous Craft Port TCP Port Number
0 1 2001
1 33 2033
2 65 2065
3 97 2097
4 129 2129
5 161 2161
6 193 2193
Command Purpose
Step 1
aic(config)# snmp
Enter SNMP configuration mode.
Step 2
aic(config)# noc ip-address {number} ip-address
Enter an NOC IP address in which the AIC will
send SNMP messages. The number argument can
be the numbers 1 through 4.
Step 3
aic(config)# exit
Exit the AIC CLI.