Specifications

4-8
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
OL-3526-05
Chapter 4 Configuring Unchannelized mode for the Cisco PA-MC-2T3+
Configuring an Unchannelized T3 Link
Examples of MDL Message Configuration
Examples of configuring MDL messages follow:
• Enter interface configuration mode first.
The example that follows is for a port adapter on a VIP in interface processor slot 1:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface serial 1/0/0
Router(config-if)#
The example that follows is for a port adapter in slot 1 of the Cisco 7200 series routers:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface serial 1/0
Router(config-if)#
• Enable the MDL path message transmission as follows:
Router(config-controller)# mdl transmit path
• Enable the MDL idle signal message transmission as follows:
Router(config-if)# mdl transmit idle-signal
• Enable the MDL test signal message transmission as follows:
Router(config-if)# mdl transmit test-signal
• Enter the equipment identification code as follows:
Router(config-if)# mdl string eic router A
• Enter the location identification code as follows:
Router(config-if)# mdl string lic tst network
• Enter the frame identification code as follows:
Router(config-if)# mdl string fic building b
• Enter the unit identification code as follows:
Router(config-if)# mdl string unit abc
• Enter the facility identification code to send in the MDL path message as follows:
Router(config-if)# mdl string pfi string
• Enter the port number to send in the MDL idle signal message as follows:
Router(config-if)# mdl string port string
• Enter the generator number to send in the MDL test signal message as follows:
Router(config-if)# mdl string generator string