Specifications

Contents

PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration

OL-3526-05

Examples of MDL Message Configuration 5-7

Configuring the Loopback Mode for the T3 Controller 5-8

Configuring the T3 controller to Enable Remote Loopback 5-9

Shutting Down the T3 Controller 5-9

Configuring T1 Lines 5-10

Creating a Logical Channel Group on a T1 Line 5-10

Removing a Logical Channel Group from a T1 Line 5-11

Setting the Framing Format on a T1 Line 5-11

Setting the Yellow Alarm Configuration for a T1 Line 5-12

Setting the Clock Source on a T1 Line 5-12

Setting the FDL Configuration for a T1 Line 5-13

Setting Loopbacks on a T1 Line 5-13

Configuring a BER Test on a T1 Line 5-16

Sending a BER Test Pattern on a T1 Line 5-17

Viewing the Results of a BER Test 5-18

Terminating a BER Test 5-23

Performing a Basic Serial Interface Configuration 5-24

Checking the Configuration 5-26

Using show Commands to Verify the New Interface Status 5-26

Using the show version or show hardware Commands 5-27

Using the show diag Command 5-31

Using the show interfaces Command 5-33

Using the show controllers Command 5-35

Displaying Remote Performance Reports 5-42

Using the ping Command to Verify Network Connectivity 5-44