Specifications

CHAPTER

2-1

PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration

OL-3526-05

Preparing for Installation

This chapter describes the general equipment, safety, and site preparation requirements for installing the

Cisco PA-MC-2T3+ port adapter. This chapter contains the following sections:

• Required Tools and Equipment, page 2-1

• Software and Hardware Requirements, page 2-2

• Checking Hardware and Software Compatibility, page 2-3

• 75-Ohm In-Line Coaxial Attenuator, page 2-3

• Safety Guidelines, page 2-3

• FCC Class A Compliance, page 2-9

Required Tools and Equipment

You need the following tools and parts to install a port adapter. If you need additional equipment, contact

a service representative for ordering information.

• PA-MC-2T3+(=) port adapter.

• Cisco 7200 VXR routers Port Adapter Jacket Card for installation of a port adapter in the I/O

controller slot (requires an NPE-G1 or NPE-G2

• VIP (for installation in Cisco 7000 series or Cisco 7500 series chassis only). Two 75-ohm 734A

coaxial cables (one for transmit and one for receive) per T3 port.

• Cisco 7304 PCI Port Adapter Carrier Card (for installation in a Cisco 7304 router).

• Number 1 Phillips and a 3/16-inch flat-blade screwdriver (for VIP installation only).

• Number 2 Phillips screwdriver.

• Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist

strap included with all upgrade kits, field-replaceable units (FRUs), and spares.

• Antistatic mat.

• Antistatic container.

• Attenuator kit (optional).