Specifications

5-40
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
OL-3526-05
Chapter 5 Configuring Channelized mode for the Cisco PA-MC-2T3+
Checking the Configuration
00:17-00:32 0 0 0 0 0 0 0 0 0 900 0
Total 0 0 0 0 0 0 0 0 0 47700 0
T1 2 is up
timeslots: 1-24
FDL per ANSI T1.403 and AT&T 54016 spec.
No alarms detected.
Framing is ESF, Clock Source is Internal
INTERVAL LCV PCV CSS SELS LES DM ES BES SES UAS SS
13:32-13:39 0 0 0 0 0 0 0 0 0 0 0
13:17-13:32 0 0 0 0 0 0 0 0 0 0 0
13:02-13:17 0 0 0 0 0 0 0 0 0 0 0
12:47-13:02 0 0 0 0 0 0 0 0 0 0 0
12:32-12:47 0 0 0 0 0 0 0 0 0 0 0
12:17-12:32 0 0 0 0 0 0 0 0 0 0 0
12:02-12:17 0 0 0 0 0 0 0 0 0 0 0
(additional displayed text not shown)
Note The PA-MC-2T3+ does not support slip buffers and always reports local controlled slip seconds (CSS)
as 0.
• show controllers t3 4/0/0 remote performance
router # show controllers t3 4/0/0 remote performance
T3 4/0/0 is up. Hardware is 2CT+ single wide port adapter
CT3 H/W Version: 0.1.0, CT3 ROM Version: 0.95, CT3 F/W Version: 0.3.9
FREEDM version: 1, reset 0
T1 1 - Remote Performance Data (Not available)
.
.
.
(additional displayed text not shown)
Note In the preceding example, remote performance data is unavailable.
If you use the show controllers T3 command without specifying a port address
(slot/port-adapter/port/t1-line-number), all information is displayed for all 28 T1 lines within every T3
port adapter in the router; therefore, the resulting display output can be extensive.
You can also display brief configuration information or tabular configuration and MIB information about
a specific T1 line within a PA-MC-2T3+ with the command:
show controllers T3 slot/port-adapter/t3-port/t1-line-number [brief | tabular | remote performance]
where:
• t1-line-number is 1–28.
• brief displays a list of configurations only.
• tabular displays a list of configurations and MIB data in a tabular format.
The following examples show command output display information for a PA-MC-2T3+ in port adapter
slot 0 on a VIP installed in interface processor slot 1, using the following commands.