Specifications

5-27
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
OL-3526-05
Chapter 5 Configuring Channelized mode for the Cisco PA-MC-2T3+
Checking the Configuration
If an interface is shut down and you configured it as up, or if the display indicates that the hardware is
not functioning properly, ensure that the interface is properly connected and terminated. If you still have
problems bringing up the interface, contact a service representative for assistance. This section includes
the following subsections:
• Using the show version or show hardware Commands, page 5-27
• Using the show diag Command, page 5-31
• Using the show interfaces Command, page 5-33
• Using the show controllers Command, page 5-35
Choose the subsection appropriate for your system. Proceed to the “Using the ping Command to Verify
Network Connectivity” section on page 5-44 when you have finished using the show commands.
Using the show version or show hardware Commands
Display the configuration of the system hardware, the number of each interface type installed, the Cisco
IOS software version, the names and sources of configuration files, and the boot images, using the show
version (or show hardware) command. Following are examples for some of the supported platforms.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
show interfaces type
port-adapter-slot-number/
T3-port-number/T1-line-number:
channel-group number
Displays status information
about a specific type of interface
(for example, serial) in a
Cisco 7200 series, Cisco 7301
router, or Cisco 7401ASR router
Router# show interfaces serial
1/0/2:0
show interfaces type module-slot-number/
T3-port-number/T1-line-number:
channel-group number
Displays status information
about a specific type of interface
(for example, serial) on a Cisco
7304 PCI Port Adapter Carrier
Card in a Cisco 7304 router
Router# show interfaces serial
1/0/2:0
show interfaces type interface-processor-
slot-number/port-adapter-slot-number/
T3-port-number/T1-line-number:channel-g
roup number
Displays status information
about a specific type of interface
(for example, serial) on a VIP in
a Cisco 7000 series or Cisco
7500 series router
Router# show interfaces serial
3/1/0/10:5
show protocols Displays protocols configured
for the entire system and for
specific interfaces
Router# show protocols
show running-config Displays the running
configuration file
Router# show running-config
show startup-config Displays the configuration
stored in NVRAM
Router# show startup-config
Table 5-3 Using show Commands (continued)
Command Function Example