Installation guide

2-29
Catalyst 3500 Series XL Hardware Installation Guide
78-6456-03
Chapter 2 Installing and Starting Up the Switch
Default Configuration Settings
Default Configuration Settings
After you assign IP information, the switch can operate with the default
configuration settings shown in Table 2-1.
Table 2-1 Default Configuration Settings
Feature Default Setting
Management
Switch IP address, subnet mask, and
default gateway
User-assigned values entered in the setup
program.
Cluster command status Enabled.
Cluster name User-assigned value entered in the setup
program.
CDP
1
Enabled.
ARP
2
Enabled.
Static address assignment None assigned.
Network View Always available.
VLAN
3
membership All ports are static-access ports in VLAN 1.
Performance
Autonegotiation of duplex mode Enabled.
Autonegotiation of port speeds Enabled.
Flooding Control
Broadcast storm control Disabled.
Flooding unknown unicast and multicast packets Enabled.
Network port Disabled.
CGMP
4
Enabled.
Network Redundancy
Spanning Tree Protocol Enabled.
Port grouping None assigned.