Specifications

2-66 Using the Operation Panel
Form Feed Time Out (Automatic form feed timeout setting)
If the printer receives no data for a certain period, it will time out and
release the current interface. It prints whatever data it has in its buffer
and feeds out the page. The default form feed timeout time is 30
seconds.
1 Press Z while >Timer > is displayed.
2 Press U or V repeatedly until >>Form Feed Time Out appears.
3 Press [OK]. A blinking cursor (_) appears.
4 Press U or V to increase or decrease the value at the blinking cursor
and set the desired time. The timeout time can be between 5 and 495
seconds, in 5-second increments. Use Y and Z to move the cursor
right and left.
5 Press [OK].
6 Press [MENU]. The display returns to Ready.
Sleep Level Set. (Sleep level setting)
For Europe
This sets whether or not the machine enters sleep mode when
connected to a network.
• ID (Administrator ID input)
• Password (Administrator Password input)
• Network (Setting for entering sleep mode when connected to a
network)
• USB Cable (Setting for entering sleep mode when connected to a
USB)
• RAM Disk (Setting for entering sleep mode when using the RAM disk)
1 Press Z while Device Common > is displayed.
2 Press U or V repeatedly until >Sleep Level Set. > appears.
ID (Administrator ID input)
To use the Sleep Level settings, you must enter an administrator ID. For
information on how to set the administrator ID, refer to Administrator
(Administrator settings) on page 2-81.
1 Press Z while >Sleep Level Set. > is displayed.
2 The message display shows ID and a blinking cursor (_).
3 Press U or V to increase or decrease, respectively, the value at the
blinking cursor. Enter the specified ID. Use Y and Z to move the
cursor right and left. Enter an ID consisting of between 1 and 16
numbers.
>>Form Feed Time Out
005
sec.
>Sleep Level Set. >
ID
_