Specifications

2-73
Cisco Catalyst Blade Switch 3040 for FSC System Message Guide
OL-10697-01
Chapter 2 Message and Recovery Procedures
VQPCLIENT Messages
Error Message VQPCLIENT-2-SHUTDOWN: Interface [chars] shutdown by VMPS.
Explanation
The VMPS has directed that an interface be shut down. [chars] is the interface name.
Recommended Action No action is normally required. If you think that the port should not have been
shut down, verify the configuration on the VMPS.
Error Message VQPCLIENT-2-TOOMANY: Interface [chars] shutdown by active host limit.
Explanation The system has shut down an interface because too many hosts have requested access to
that port. [chars] is the interface name.
Recommended Action To reactivate the port, remove the excess hosts, and enter a no shutdown
interface configuration command on the interface.
Error Message VQPCLIENT-3-IFNAME: Invalid interface ([chars]) in response.
Explanation
The VMPS has sent an unsolicited response with an unknown interface name. [chars] is
the name of the unknown interface.
Recommended Action Verify the VMPS configuration.
Error Message VQPCLIENT-3-THROTTLE: Throttling VLAN change on [chars].
Explanation
An attempt was made to change the VLAN assignment for an interface more often than
once every 10 seconds. The VLAN change is denied. [chars] is the interface name.
Recommended Action No action is normally required. If the message recurs, verify the VMPS
configuration. Verify that unexpected hosts are not connected to the port.
Error Message VQPCLIENT-3-VLANNAME: Invalid VLAN ([chars]) in response.
Explanation The VMPS has specified a VLAN name that is unknown to the switch. [chars] is the
invalid VLAN name.
Recommended Action Make sure that the VLAN exists on the switch. Verify the VMPS configuration.
Error Message VQPCLIENT-7-NEXTSERV: Trying next VMPS [IP_address].
Explanation
The system has lost connectivity with the current VMPS and is changing to the next
server in its list. [IP_address] is the address of the next server in the list.
Recommended Action This is a debug message only. No action is required.