Specifications

2-49
Cisco Catalyst Blade Switch 3040 for FSC System Message Guide
OL-10697-01
Chapter 2 Message and Recovery Procedures
RMON Messages
Error Message QOSMGR-4-POLICER_POLICY_NOT_SUPPORTED: Number of policers has exceeded
per policy hardware limitation for policymap [chars].
Explanation
The policy-map configuration has exceeded the limitation of the hardware. You
configured more policers in a policy map (by using the police or police aggregate policy-map class
configuration command) than supported. [chars] is the policy-map name.
Recommended Action Reconfigure the class map or the policy map, and reduce the number of
policers.
RMON Messages
This section contains the remote network monitoring (RMON) messages.
Error Message RMON-5-FALLINGTRAP: Falling trap is generated because the value of
[chars] has fallen below the falling-threshold value [dec].
Explanation
A falling trap has been generated. The value of the specified MIB object has fallen
below the falling threshold value. [chars] is the MIB object, and [dec] is the threshold value.
Recommended Action Take appropriate action on the specified MIB object.
Error Message RMON-5-RISINGTRAP: Rising trap is generated because the value of
[chars] exceeded the rising-threshold value [dec].
Explanation A rising trap has been generated. The value of the specified MIB object has exceeded
the rising threshold value. [chars] is the MIB object, and [dec] is the threshold value.
Recommended Action Take appropriate action on the specified object.
SPAN Messages
This section contains the Switched Port Analyzer (SPAN) messages.
Error Message SPAN-3-MEM_UNAVAIL: Memory was not available to perform the SPAN
operation.
Explanation The system was unable to perform a SPAN operation because of a lack of memory.
Recommended Action Reduce other system activity to ease the memory demands.
Error Message SPAN-3-UNKN_ERR: An internal error occurred during a SPAN operation.
Explanation SPAN detected an error in its internal operation.
Recommended Action The error might be transient. Try the SPAN operation again. If a second attempt
also fails, reload the switch by using the reload privileged EXEC command to complete the
operation.