Specifications

2-48
Cisco Catalyst Blade Switch 3040 for FSC System Message Guide
OL-10697-01
Chapter 2 Message and Recovery Procedures
QOSMGR Messages
Error Message QOSMGR-4-HARDWARE_NOT_SUPPORTED: Hardware limitation has reached for
policymap [chars].
Explanation
The policy-map configuration has exceeded the limitation of the hardware. You
configured more QoS ACL entries than the number specified in the Switch Database Management
(SDM) template. [chars] is the policy-map name.
Recommended Action Reconfigure the class map or the policy map, and reduce the number of QoS
ACLs.
Error Message QOSMGR-4-MATCH_NOT_SUPPORTED: Match type is not supported in classmap
[chars].
Explanation An unsupported match type was entered. Only the access-group acl-index-or-name, ip
dscp dscp-list, and ip precedence ip-precedence-list match types are supported with the match
class-map configuration command. [chars] is the class-map name.
Recommended Action Reconfigure the class map; use only the match access-group, match ip dscp,
and match ip precedence class-map configuration commands within the class map.
Error Message QOSMGR-4-NOT_SUPPORTED: Action ’[chars]’ is not supported for a
policymap attached to output side.
Explanation
A set or trust policy-map class configuration command was configured in a policy map
and attached to an egress interface. A warning message is logged, and the actions do not take effect.
This is a hardware limitation. [chars] is either the set or trust action.
Recommended Action Do not configure a set or trust policy-map class configuration command in a
policy map and attach it to an egress interface. These policy-map actions are supported only on
ingress interfaces.
Error Message QOSMGR-4-POLICER_PLATFORM_NOT_SUPPORTED: Policer configuration has
exceeded hardware limitation for policymap [chars].
Explanation
The policy-map configuration has exceeded the limitation of the hardware. You
configured more policers together in all policy maps (by using the police or police aggregate
policy-map class configuration command) than supported by hardware. [chars] is the policy-map
name.
Recommended Action Reconfigure the class maps or the policy maps, or delete the policy map from
some interfaces.