Specifications

2-15
Cisco Catalyst Blade Switch 3040 for FSC System Message Guide
OL-10697-01
Chapter 2 Message and Recovery Procedures
DTP Messages
Error Message DOT1X_SWITCH-5-ERR_VLAN_PROMISC_PORT: Assigning a dot1x VLAN [dec] to
a promiscuous port [chars] is not allowed
Explanation
An attempt was made to assign a VLAN to a supplicant on a promiscuous port, which
is not allowed. [dec] is the VLAN ID and [chars] is the port.
Recommended Action Change the port mode to a nonpromiscuous port.
Error Message DOT1X_SWITCH-5-ERR_VLAN_RESERVED: The VLAN [dec] is a reserved vlan
and cannot be assiged for use on the Dot1x port [chars] Vlan
Explanation The specified VLAN is reserved and cannot be assigned for use on this port. [dec] is the
VLAN ID, and [chars] is the port.
Recommended Action Configure a different VLAN for the port.
Error Message DOT1X_SWITCH-5-ERR_VLAN_RSPAN: Attempt by 802.1x to assign RSPAN VLAN
[dec]. 802.1x is incompatible with RSPAN
Explanation
You cannot configure remote SPAN on a VLAN assigned to IEEE 802.1x-enabled ports
Recommended Action Either disable the remote SPAN configuration on the VLAN, or disable the
IEEE 802.1x configuration on all the ports in the VLAN.
DTP Messages
This section contains the Dynamic Trunking Protocol (DTP) messages.
Error Message DTP-4-MEM_UNAVAIL: Memory was not available to perform the trunk
negotiation action.
Explanation
The system is unable to negotiate trunks because of a lack of memory.
Recommended Action Reduce other system activity to ease memory demands.
Error Message DTP-4-TMRERR: An internal timer error occurred when trunking on
interface [chars].
Explanation
A timer used by the trunking protocol unexpectedly expired. [chars] is the trunked
interface.
Recommended Action This problem is corrected internally and has no long-term ramifications.
However, if more problems with trunking occur, reload the switch by using the reload privileged
EXEC command.