Specifications

2-14
Cisco Catalyst Blade Switch 3040 for FSC System Message Guide
OL-10697-01
Chapter 2 Message and Recovery Procedures
DOT1X_SWITCH Messages
Error Message DOT1X_SWITCH-5-ERR_SPAN_DST_PORT: Assigning a dot1x VLAN [dec] to a
SPAN destination port [chars] is not allowed
Explanation
You cannot assign an IEEE 802.1x VLAN to a port that is configured as a SPAN
destination port.
Recommended Action Update the configuration to use a different VLAN, or disable the RSPAN
VLAN.
Error Message DOT1X_SWITCH-5-ERR_VLAN_EQ_VVLAN: Data VLAN [dec] on port [chars]
cannot equal to Voice VLAN.
Explanation
The IEEE 802.1x-assigned VLAN on a port cannot be the same as the voice VLAN.
[dec] is the data VLAN ID, and [chars] is the port.
Recommended Action Configure either a different voice VLAN or a different IEEE 802.1x-assigned
access VLAN on the interface. The authentication then proceeds normally on the next retry.
Error Message DOT1X_SWITCH-5-ERR_VLAN_INTERNAL: The VLAN [dec] is being used
internally and cannot be assiged for use on the Dot1x port [chars] Vlan
Explanation
The specified VLAN ID is already used internally and cannot be assigned to the IEEE
802.1x VLAN on this port. [dec] is the VLAN ID already in use, and [chars] is the port.
Recommended Action Configure a different VLAN ID for the IEEE 802.1x VLAN on this port.
Error Message DOT1X_SWITCH-5-ERR_VLAN_INVALID: The VLAN [dec] is invalid and cannot
be assiged for use on the Dot1x port [chars] Vlan
Explanation
The specified VLAN ID is out of range and cannot be configured on this port. [dec] is
the VLAN ID, and [chars] is the port.
Recommended Action Configure a valid VLAN ID.
Error Message DOT1X_SWITCH-5-ERR_VLAN_NOT_FOUND: Attempt to assign non-existent or
shutdown VLAN [dec] to dot1x port [chars]
Explanation The VLAN assigned to a supplicant on a port was not found in the VTP database. [dec]
is the number of the assigned VLAN, and [chars] is the port.
Recommended Action Make sure that the specified VLAN is properly configured, or configure
another VLAN.
Error Message DOT1X_SWITCH-5-ERR_VLAN_ON_ROUTED_PORT: Dot1x cannot assign a VLAN
[dec] to a routed port [chars]
Explanation
An attempt was made to assign a VLAN to a supplicant on a routed port, which is not
allowed. [dec] is the VLAN ID and [chars] is the port.
Recommended Action Either disable the VLAN assignment, or change the port type to a nonrouted
port.