Specifications

2-13
Cisco Catalyst Blade Switch 3040 for FSC System Message Guide
OL-10697-01
Chapter 2 Message and Recovery Procedures
DOT1X_SWITCH Messages
Error Message DOT1X-5-SECURITY_VIOLATION: Security violation on interface [chars],
New MAC address [enet]
Explanation
The port on the specified interface has been disabled because of a security violation.
When an interface is configured in single-host mode, any new host that is detected on the interface
is treated as a security violation. [chars] is the interface number, and [enet] is the MAC address of
the new host.
Recommended Action Ensure that the port is configured to use only one host. Enter the shutdown
interface configuration command. Then enter the no shutdown interface configuration command to
restart the port.
DOT1X_SWITCH Messages
This section contains the IEEE 802.1x messages for switches.
Error Message DOT1X_SWITCH-5-ERR_INVALID_PRIMARY_VLAN: Primary VLAN [dec] cannot be
assigned to dot1x port [chars]
Explanation
An attempt was made to assign a primary VLAN on an IEEE 802.1x enabled port. [dec]
is the VLAN ID and [chars] is the port.
Recommended Action Update the configuration to use a nonprimary VLAN.
Error Message DOT1X_SWITCH-5-ERR_INVALID_SEC_VLAN: Assignment of invalid secondary
VLAN [dec] on PVLAN host port [chars]
Explanation An attempt was made to assign a nonsecondary IEEE 802.1x VLAN on a private VLAN
host port. [dec] is the VLAN ID and [chars] is the port.
Recommended Action Update the configuration to use a different VLAN, or change the port mode to
match the VLAN type.
Error Message DOT1X_SWITCH-5-ERR_SEC_VLAN_INVALID: Secondary VLAN [dec] cannot be
assigned to non-PVLAN host port [chars]
Explanation
An attempt was made to assign a secondary VLAN to a port that is not a private VLAN
host port, which is not allowed. [dec] is the VLAN ID and [chars] is the port.
Recommended Action Update the configuration to use a different VLAN, or change the port mode to
match the VLAN type.