Specifications

2-12
Cisco Catalyst Blade Switch 3040 for FSC System Message Guide
OL-10697-01
Chapter 2 Message and Recovery Procedures
DOT1X Messages
DOT1X Messages
This section contains the IEEE 802.1x messages.
Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the
802.1X action.
Explanation
The system memory is not sufficient to perform the IEEE 802.1x authentication.
Recommended Action Reduce other system activity to reduce memory demands.
Error Message DOT1X-4-PROC_START_ERR: Dot1x unable to start.
Explanation
The system failed to start the IEEE 802.1x process.
Recommended Action Restart the IEEE 802.1x process by entering the dot1x system-auth-control
global configuration command. If this message recurs, reload the device.
Error Message DOT1X-4-UNKN_ERR: An unknown operational error occurred.
Explanation The IEEE 802.1x process cannot operate because of an internal system error.
Recommended Action Reload the device.
Error Message DOT1X-5-ERR_INVALID_AAA_ATTR: Got invalid AAA attribute settings
[chars].
Explanation The authorization settings obtained are either unsupported or invalid. [chars] is the text
received from the RADIUS server.
Recommended Action Change the settings to valid values.
Error Message DOT1X-5-ERR_PER_USR_IP_ACL: Applied per-user IP ACL was unsuccessful
on interface [chars].
Explanation
IEEE 802.1x could not apply a per-user IP ACL, possibly because of an invalid per-user
base (or pub) ACL from the RADIUS server. [chars] is the interface.
Recommended Action Examine the RADIUS pub ACL, and configure a valid one.
Error Message DOT1X-5-ERR_PER_USR_MAC_ACL: Applied per-user MAC ACL was unsuccessful
on interface [chars].
Explanation
IEEE 802.1x could not apply a per-user MAC ACL, possibly because of an invalid
per-user base (or pub) ACL from the RADIUS server. [chars] is the interface.
Recommended Action Examine the RADIUS pub ACL, and configure a valid one.