Specifications

2-7
Cisco Catalyst Blade Switch 3040 for FSC System Message Guide
OL-10697-01
Chapter 2 Message and Recovery Procedures
CMP Messages
Error Message BSPATCH-1-PATCHED: Boot Loader patch ([chars]) installed.
Explanation
A boot loader patch is installed successfully. [chars] is the SDRAM refresh timer
register setting.
Recommended Action If this message recurs, copy it exactly as it appears on the console or in the
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still require assistance, open a case with the
TAC, or contact your Cisco technical support representative, and provide the representative with the
gathered information. For more information about these online tools and about contacting Cisco, see the
“Error Message Traceback Reports” section on page 1-2.
Error Message BSPATCH-3-FAILED: Failed to install Boot Loader patch ([chars]).
Explanation The switch failed to apply a boot loader patch. [chars] is the SDRAM refresh timer
register setting.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the “Error
Message Traceback Reports” section on page 1-2.
CMP Messages
This section contains the Cluster Membership Protocol (CMP) messages.
Error Message CMP-4-MEM_CMPIP_ADDR_CONFLICT: Conflict with CMP IP address
[IP_address], Reissuing a new CMP IP address to member [dec]
Explanation
The cluster commander found a conflict with the assigned CMP IP address of the
member. A new unique CMP IP address is assigned to the member. [dec] is the member number.
Recommended Action This is only a warning message. The commander has already assigned the
cluster member a new unique address. Clear any open TCP connections on the member by using
clear tcp privileged EXEC command.
Error Message CMP-5-ADD: The Device is added to the cluster (Cluster Name: [chars],
CMDR IP Address [IP_address]).
Explanation The device is added to the cluster. [chars] is the cluster name, and [IP_address] is the
Internet address of the command switch.
Recommended Action No action is required.