Installation guide

2-14
Cisco Catalyst Blade Switch 3040 for FSC Hardware Installation Guide
OL-10694-01
Chapter 2 Blade Switch Installation
Overview of Steps for Installing and Initially Configuring the Blade Switch
Step 8 To configure the interface, enter Ye s after the prompt, and then enter the blade switch IP address and
subnet mask. Press Return.
The IP address and subnet mask shown here are examples:
Configuring interface Vlan1:
Configure IP on this interface? [yes]: Yes
IP address for this interface [10.0.0.1]: 10.0.0.1
Subnet mask for this interface [255.255.255.0] : 255.255.255.0
Class A network is 10.0.0.1, 21 subnet bits; mask is /21
Step 9 Enter no when the prompt asks you if you would like to enable the blade switch as a cluster command
switch. This is a standalone blade switch.
Would you like to enable as a cluster command switch? [yes/no]: no
Note The Cisco Catalyst Blade Switch 3040 for FSC does not support clustering.
You have now completed the initial configuration. An example of the output is shown here:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$cagJ$e4LP91PNazfdADoNAZm6y0
enable password
enable_password
line vty 0 15
password
terminal-password
snmp-server community public
!
!
interface Vlan1
no shutdown
ip address 10.0.0.1 255.255.255.0
!
interface GigabitEthernet0/1
!
interface GigabitEthernet0/2
. . . (output truncated)
interface GigabitEthernet0/16
!
end
Step 10 These choices appear. Enter 2, and then press Return.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you want to save the configuration and use it the next time the switch reboots, save it
in NVRAM by selecting option 2.
Enter your selection [2]:2
Make your selection, and press Return.
Step 11 If you plan to set up more than one blade switch, enter Ctrl-Q to return to the Console Redirect Switch
Blade menu, and choose the next blade switch. When you have set up all of the blade switches, enter 0
on the Console Redirect Switch Blade menu to return to the management blade Console Main menu.
This re-enables the blade switch console port.