Specifications

2-315
Cisco Catalyst Blade Switch 3020 for HP Command Reference
OL-8916-01
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
show interfaces
Queueing strategy: fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
2 packets input, 1040 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
4 packets output, 1040 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
This is an example of output from the show interfaces accounting command.
Switch# show interfaces accounting
Vlan1
Protocol Pkts In Chars In Pkts Out Chars Out
IP 1094395 131900022 559555 84077157
Spanning Tree 283896 17033760 42 2520
ARP 63738 3825680 231 13860
Interface Vlan2 is disabled
Vlan7
Protocol Pkts In Chars In Pkts Out Chars Out
No traffic sent or received on this interface.
Vlan31
Protocol Pkts In Chars In Pkts Out Chars Out
No traffic sent or received on this interface.
GigabitEthernet0/21
Protocol Pkts In Chars In Pkts Out Chars Out
No traffic sent or received on this interface.
GigabitEthernet0/22
Protocol Pkts In Chars In Pkts Out Chars Out
No traffic sent or received on this interface.
<output truncated>
This is an example of output from the show interfaces capabilities command for an interface.
Switch# show interfaces gigabitethernet0/21 capabilities
GigabitEthernet0/2
Model: WS-CBS3020-HPQ
Type: 10/100/1000BaseTX
Speed: 10,100,1000,auto
Duplex: half,full,auto
Trunk encap. type: 802.1Q,ISL
Trunk mode: on,off,desirable,nonegotiate
Channel: yes
Broadcast suppression: percentage(0-100)
Flowcontrol: rx-(off,on,desired),tx-(none)
Fast Start: yes
QoS scheduling: rx-(not configurable on per port basis),tx-(4q2t)
CoS rewrite: yes
ToS rewrite: yes
UDLD: yes
Inline power: no
SPAN: source/destination
PortSecure: yes
Dot1x: yes