Specifications

2-314
Cisco Catalyst Blade Switch 3020 for HP Command Reference
OL-8916-01
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
show interfaces
Note Though visible in the command-line help strings, the crb, fair-queue, irb, mac-accounting,
precedence, random-detect, rate-limit, and shape keywords are not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines The show interfaces capabilities command with different keywords has these results:
• Use the show interface capabilities module 1 to display the capabilities of all interfaces on the
switch. Entering any other number is invalid.
• Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
• Use the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces on the switch.
• Use the show interface switchport module 1 to display the switch port characteristics of all
interfaces on the switch. Entering any other number is invalid.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show interfaces command for an interface:
Switch# show interfaces gigabitethernet0/22
GigabitEthernet0/22 is down, line protocol is down
Hardware is Gigabit Ethernet, address is 0009.43a7.d085 (bia 0009.43a7.d085)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
trunk Display interface trunk information. If you do not specify an interface, only
information for active trunking ports appears.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
1. coarse wavelength-division multiplexer
2. dense wavelength-division multiplexer
Release Modification
12.2(25)SEF This command was introduced.