Specifications

CHAPTER
1-1
Cisco Catalyst Blade Switch 3020 for HP Command Reference
OL-8916-01
1
Using the Command-Line Interface
The switch is supported by Cisco IOS software. This chapter describes how to use the switch
command-line interface (CLI) to configure software features.
• For a complete description of the commands that support these features, see Chapter 2, “Cisco
Catalyst Blade Switch 3020 for HP Cisco IOS Commands.”
• For information on the boot loader commands, see Appendix A, “Cisco Catalyst Switch 3020 for
HP Boot Loader Commands.”
• For information on the debug commands, see Appendix B, “Cisco Catalyst Blade Switch 3020 for
HP Debug Commands.”
• For information on the show platform commands, see Appendix C, “Cisco Catalyst Blade Switch
3020 for HP Show Platform Commands.”
• For more information on Cisco IOS Release 12.2, see the Cisco IOS Release 12.2 Command
Summary.
• For task-oriented configuration steps, see the software configuration guide for this release.
In this document, IP refers to IP version 4 (IPv4).
CLI Command Modes
This section describes the CLI command mode structure. Command modes support specific Cisco IOS
commands. For example, the interface interface-id command only works when entered in global
configuration mode.
These are the main command modes for the switch:
• User EXEC
• Privileged EXEC
• Global configuration
• Interface configuration
• Config-vlan
• VLAN configuration
• Line configuration