Specifications

ManualsBrandsCisco ManualsComputer equipment3020 - Cisco Catalyst Blade Switch

111

112

113

114

115

116

117

118

119

120

2-88

Cisco Catalyst Blade Switch 3020 for HP Command Reference

OL-8916-01

Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands

errdisable recovery

Use the errdisable recovery global configuration command to configure the recover mechanism

variables. Use the no form of this command to return to the default setting.

errdisable recovery {cause {all | bpduguard | channel-misconfig | dhcp-rate-limit | dtp-flap |

| vmps} | {interval interval}

no errdisable recovery {cause {all | bpduguard | channel-misconfig | dhcp-rate-limit | dtp-flap

| vmps} | {interval interval}

Syntax Description cause Enable the error-disabled mechanism to recover from a specific cause.

all Enable the timer to recover from all error-disabled causes.

bpduguard Enable the timer to recover from the bridge protocol data unit (BPDU) guard

error-disabled state.

channel-misconfig Enable the timer to recover from the EtherChannel misconfiguration

error-disabled state.

dhcp-rate-limit Enable the timer to recover from the DHCP snooping error-disabled state.

dtp-flap Enable the timer to recover from the Dynamic Trunking Protocol (DTP) flap

error-disabled state.

gbic-invalid Enable the timer to recover from an invalid Gigabit Interface Converter

(GBIC) module error-disabled state.

Note This error refers to an invalid small form-factor pluggable (SFP)

error-disabled state.

link-flap Enable the timer to recover from the link-flap error-disabled state.

loopback Enable the timer to recover from a loopback error-disabled state.

pagp-flap Enable the timer to recover from the Port Aggregation Protocol (PAgP)-flap

error-disabled state.

psecure-violation Enable the timer to recover from a port security violation disable state.

security-violation Enable the timer to recover from an IEEE 802.1x-violation disabled state.

udld Enable the timer to recover from the UniDirectional Link Detection (UDLD)

error-disabled state.

vmps Enable the timer to recover from the VLAN Membership Policy Server

(VMPS) error-disabled state.

interval interval Specify the time to recover from the specified error-disabled state. The range

is 30 to 86400 seconds. The same interval is applied to all causes. The default

interval is 300 seconds.

Note The error-disabled recovery timer is initialized at a random

differential from the configured interval value. The difference

between the actual timeout value and the configured value can be up

to 15 percent of the configured interval.