Specifications

2-85
Cisco Catalyst Blade Switch 3020 for HP Command Reference
OL-8916-01
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
duplex
Caution Changing the interface speed and duplex mode configuration might shut down and re-enable the
interface during the reconfiguration.
For guidelines on setting the switch speed and duplex parameters, see the “Configuring Interface
Characteristics” chapter in the software configuration guide for this release.
Examples This example shows how to configure an interface for full-duplex operation:
Switch(config)# interface gigabitethernet0/21
Switch(config-if)# duplex full
You can verify your setting by entering the show interfaces privileged EXEC command.
Related Commands Command Description
show interfaces Displays the interface settings on the switch.
speed Sets the speed on a 10/100/1000 Mbps interface.