System information
41
Release Notes for Cisco VPN 3000 Series Concentrator, Release 3.6 Through 3.6.8.B
OL-5637-02
Caveats Resolved in Release 3.6.3
• CSCdy41307
Internet Explorer does not display any remote access users in the admin or monitoring session tables
if any user specifies a domain upon connecting.
The table is displayed in Netscape but the separating '\' is not displayed.
For example: User: test Domain: Lab.com
should be displayed in the table as Lab.com\test, but Netscape displays it as Lab.comtest.
• CSCdy49334
The VPN 3000 Concentrator might fail with an out-of-memory error during heavy memory usage.
During heavy memory usage, memory was not being properly freed.
The crashdump exhibits the following symptoms:
–
ASSERT >> Malloc() failed
–
Memory corruption detected with TID = [0x00000000] and Size = [0]
• CSCdy52196
VPN 3000 Concentrator can fail with cTCP client and a large network list.
• CSCdy52938
Cannot Set Access Session Timeout to 0, although the error message says that 0 is within the
acceptable range.
• CSCdy57163
The VPN 3000 Concentrator fails to install CA chains if any two of the certificates are identical in
the first 4 bytes of their serial numbers.
• CSCdy58124
Given the following setup:
NT PDC---vpn3k---Internet
When we configure a group with the same name as a domain username and then test the
authentication against the NTPDC, it fails.
This is not a valid configuration. Users and groups cannot share common names.
• CSCdy62382
When the administrator enters username/password after configuring TACACS authentication for
Administrator access to the GUI, the VPN 3000 Concentrator fails.
This occurs if other TACACS attributes are assigned besides “priv-lvl”.
• CSCdy64996
A VPN 3000 Concentrator, renewing DHCP, sends the request to the broadcast address
(255.255.255.255) instead of the IP address of the DHCP server.
• CSCdy73188
In version 3.6, int_12, under session details (3060) for a remote access session (Hardware or
software client), the Auth mode for the IKE session displays “other” when it should be “Preshared
Keys - XAUTH”. The session details under CLI correctly displays 'Pre-XTH.