Specifications

C-11
VPN 3000 Series Concentrator Reference: Administration and Monitoring
78-13274-01
Appendix C Copyrights, Licenses, and Notices
Regulatory Standards Compliance
FCC Part 68 Notice
The equipment complies with Part 68 of the FCC rules. On the tray of this equipment is a label that
contains, among other information, the FCC registration number. If requested, this information must be
provided to the telephone company.
This equipment cannot be used on telephone company-provided coin services. Connection to the Party
Line Service is subject to state tariffs.
If this equipment causes harm to the telephone network, the telephone company notifies you in advance
that temporary discontinuance of service might be required. If advance notice is not practical, the
telephone company notifies the customer as soon as possible. Also, you are advised of your right to file
a complaint with the FCC if you believe it is necessary.
The telephone company can make changes in its facilities, equipment, operations, or procedures that
could affect the operation of the equipment. If this happens, the telephone company provides advance
notice in order for you to make the necessary modifications to maintain uninterrupted service.
If trouble is experienced with this equipment, please contact us for repair and warranty information. If
the trouble is causing harm to the telephone network, the telephone company can request you remove
the equipment from the network until the problem is resolved.
We recommend that you install an AC surge arrestor in the AC outlet to which this device is connected.
This is to avoid damaging the equipment caused by local lightning strikes and other electrical surges.
This equipment uses the Uniform Service Order Code (USOC) jacks described below.
CS-03 Certification
The equipment is CS-03 certified. Refer to Table C-1 for CS03 approval details for equipment. Observe
the following general information and safety precautions:
The industry Canada label identifies CS-03 certified equipment. This certification means that the
equipment meets certain telecommunications network protection, operation, and safety requirements as
described in the appropriate terminal equipment requirements document(s). The department does not
guarantee the equipment will operate to the user’s satisfaction.
Before installing the equipment, ensure that it is permissible to connect them to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of
connection. The customer should be aware that compliance with the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any
repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the equipment.
Ensure that the electrical ground connections of the power utility, telephone lines, and internal metallic
water pipe system, if present, are connected together. This precaution may be particularly important in
rural areas.
Model Name Facility Interface Code Service Order Code Jack Type
CVPN_3000-2T 04DU9-1SN 6.0N RJ48C