System information

VPN Concentrator Configuration 141
The concentrator only presents the Quick Configuration process upon initial bootup using the
default configuration. After you have configured the concentrator, the normal CLI menus look
as follows:
Model 3005 menu:
1) Modify Ethernet 1 IP Address (Private)
2) Modify Ethernet 2 IP Address (Public)
3) Configure Expansion Cards
4) Save changes to Config file
5) Continue
6) Exit
Quick -> _
Model 3015–3080 menu:
1) Modify Ethernet 1 IP Address (Private)
2) Modify Ethernet 2 IP Address (Public)
3) Modify Ethernet 3 IP Address (External)
4) Configure Expansion Cards
5) Save changes to Config file
6) Continue
7) Exit
Quick -> _
If you need to go through the Quick Configuration again for any reason, simply select the
Reboot with Factory/Default Configuration option from the Administration | System
Reboot menu in the VPN 3000 Concentrator Manager.
This finishes the CLI configuration steps. The remainder of the configuration steps are
completed using the Cisco VPN 3000 Concentrator Manager application that is resident on
each VPN concentrator and is accessible using the web browser on your administrator PC.
Quick Configuration Using the Browser-Based Manager
Now that you have configured the Private interface on the VPN concentrator, make sure that
your workstation has an IP address on the same subnet as the concentrator and verify that
you can reach the concentrator by pinging to it from the workstation. Once you have verified
connectivity, open your web browser application and connect to the concentrator by entering
the IP address of the concentrator in the Address field of the browser, as shown in Figure 4-3.
2) Modify Ethernet 2 IP Address (Public)
3) Save changes to Config file
4) Continue
5) Exit
Quick -> 5
Example 4-4 Saving Configuration Settings and Exiting the CLI (Continued)
chpt_04.fm Page 141 Friday, April 4, 2003 9:19 AM