System information

VPN Concentrator Configuration 139
Configuring the Private LAN Interface
The next phase of the CLI Quick Configuration steps is to configure the Private LAN interface.
This is simply a matter of setting the IP address and subnet mask information and then speci-
fying the speed and duplex mode to use for the interface. Those steps are shown in the output
in Example 4-3, which is displayed as soon as you enter your preference for daylight-savings
support.
-- : 0 : GMT +1 : Paris +2 : Cairo +3 : Kuwait
-- : +4 : Abu Dhabi +5 : Karachi +6 : Almaty +7 : Bangkok
-- : +8 : Singapore +9 : Tokyo +10 : Sydney +11 : Solomon Is.
-- : +12 : Marshall Is.
> Time Zone
Quick -> [ 0 ] -6
1) Enable Daylight Savings Time Support
2) Disable Daylight Savings Time Support
Quick -> [ 1 ] 2
Example 4-3 Configuring the Private Interface
This table shows current IP addresses.
Intf Status IP Address/Subnet Mask MAC Address
-------------------------------------------------------------------------------
Ether1-Pri|Not Configured| 0.0.0.0/0.0.0.0 |
Ether2-Pub|Not Configured| 0.0.0.0/0.0.0.0 |
-------------------------------------------------------------------------------
DNS Server(s): DNS Server Not Configured
DNS Domain Name:
Default Gateway: Default Gateway Not Configured
** An address is required for the private interface. **
> Enter IP Address
Quick Ethernet 1 -> [ 0.0.0.0 ] 192.168.1.3
Waiting for Network Initialization...
> Enter Subnet Mask
Quick Ethernet 1 -> [ 255.255.255.0 ]
1) Ethernet Speed 10 Mbps
continues
Example 4-2 Setting the System Time and Date (Continued)
chpt_04.fm Page 139 Friday, April 4, 2003 9:19 AM