Specifications

4-14

VPN 3000 Series Concentrator Getting Started

78-15733-03

Chapter 4 Using the Command-Line Interface for Quick Configuration

Configuring the IPSec Group

This section appears only if you enable the IPSec tunneling protocol.

The remote-access IPSec client connects to the VPN Concentrator via this group name and password,

which are automatically configured on the internal authentication server. This is the IPSec group that

creates the tunnel. Users then log in, and are authenticated, by means of their usernames and passwords.

To configure the IPSec group name and password, follow these steps:

Step 1 The system prompts you to enter the IPSec group name.

> IPSec Group Name

Quick -> _

At the cursor, enter a unique name for this group. Maximum is 32 characters, case-sensitive; for example,

Group1.

Step 2 The system prompts you to enter the group password.

> IPSec Group Password

Quick -> _

At the cursor, enter a unique password for this group. The minimum is 4, and the maximum is 32

characters, case-sensitive. The system displays only asterisks.

Step 3 The system prompts you to reenter the group password to verify it.

Verify -> _

At the cursor, reenter the group password. The system displays only asterisks.

Configuring WebVPN Remote Access

The following prompts appear only if you enabled WebVPN. (See “Configuring Tunneling Protocols and

Options.”)

This section describes how to enable HTTPS and mail protocols for WebVPN and how to configure basic

WebVPN parameters. To use any of the browser-based WebVPN features, enable HTTPS. To use e-mail

proxy, enable the protocol(s) that your mail server uses: POP3S, SMTPS, or IMAP4S.

Step 1 The system prompts you to enable or disable HTTPS on the Public interface. If you did not configure

the Public interface, the prompt applies to the Private interface instead.

Select the protocols to enable/disable on the Public interface (or Private interface if

you do not configure the Public interface), and the default system-wide e-mail servers for

WebVPN services.

1) Enable HTTPS

2) Disable HTTPS

Quick -> [ 1 ] _

At the cursor, enter 2 to disable HTTPS, or press Enter to accept the default (1), which enables HTTPS.