Specifications

4-22
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-07
Chapter 4 Getting Started with CMS
Menus and Toolbar
.
The Link Report and Link Graph options are not available if at both ends of the link are one of these:
• Candidate switches
• Catalyst 1900 and Catalyst 2820 switches
• Devices that are not eligible to join the cluster
If multiple links are configured between two devices, when you click the link icon and right-click, the
Logical Link Content window appears, as shown in Figure 4-9. Click the link icon in this window, and
right-click to display the link popup menu specific for that link.
Figure 4-9 Logical Link Window
Device Popup Menus
Table 4-16 through Table 4-21 list the popup menus for specific devices:
• Cluster (Table 4-16)
• Command switch (Table 4-17)
• Member or standby command switch (Table 4-18)
• Candidate switch with an IP address (Table 4-19)
Table 4-15 Link Popup Menu
Link Popup Menu Task
Link Report Display the link report for two connected devices. If one device is an unknown
device or a candidate, only the cluster member side of the link displays.
Link Graph Display a graph showing the current bandwidth used by the selected link. You
can change the graph polling interval by selecting CMS > Preferences.
Properties Display information about the device and port on either end of the link and the
state of the link.