Specifications

4-21
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-07
Chapter 4 Getting Started with CMS
Menus and Toolbar
Port Popup Menu
You can display all port configuration windows from the Port menu on the menu bar, or you can display
commonly-used port configuration windows from the port popup menu, as listed in Table 4-14. To
display the port popup menu, click a specific port image, and right-click.
Topology View Popup Menus
These popup menus are available in the Topology view.
Link Popup Menu
Table 4-15 lists the reports and graphs that you can display for a specific link in the Topology view. To
display the link popup menu, click the link icon, and right-click.
Table 4-13 Device Popup Menu
Popup Menu Option Task
Device Manager
1
1. Available from a cluster member switch but not from the command switch.
Launch Device Manager for the switch.
Host Name
2
2. Not available in read-only mode. For more information about the read-only mode, see the “Access Modes in CMS” section
on page 4-30.
Change the name of the switch.
Delete Cluster
2 3 4
3. Available only from the command switch.
4. Available only from a cluster-management session.
Delete a cluster.
Remove from Cluster
2 4
Remove a member from the cluster.
Bandwidth Graphs Display graphs that plot the total bandwidth in use.
Properties Display information about the device and port on either end of the link
and the state of the link.
Table 4-14 Port Popup Menu
Popup Menu Option Task
Port Settings
1
1. Some options from this menu are not available in read-only mode.
Display and configure port settings.
VLAN
1
Define the VLAN mode for a port or ports and add ports to VLANs. Not
available for the Catalyst 1900 and Catalyst 2820 switches.
Port Security
1 2 3
2. Available on switches that support the Port Security feature.
3. This feature is not available in read-only mode.
Enable port security on a port.
Link Graphs
4
4. Available only when there is an active link on the port (that is, the port LED is green when in port status mode).
Display a graph showing the bandwidth used by the selected link.
Select All Ports Select all ports on the switch for global configuration.