Specifications

Index
IN-4
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-07
BPDU guard
described
14-3
enabling 14-15
support for 1-4
broadcast storm control
configuring
19-2
disabling 19-3
browser configuration 4-1, 7-1
buttons, CMS 4-28
C
cables, monitoring for unidirectional links 20-1
candidate switch
adding
7-21
automatic discovery 7-6
defined 7-5
HC 7-24
passwords 7-21
requirements 7-5
standby group 7-23
See also command switch, cluster standby group, and
member switch
Catalyst 2955
configuring alarm profiles
attaching an alarm profile to a port
3-11
creating or modifying alarm profiles 3-10
configuring switch alarms 3-1 to 3-12
configuring the FCS bit error rate alarm
setting the FCS error hysteresis threshold
3-9
setting the FCS error threshold 3-8
configuring the power supply alarm
setting the power mode
3-5
setting the power supply alarm options 3-6
configuring the temperature alarms
associating the temperature alarms to a relay
3-7
setting a secondary temperature threshold 3-7
default alarm configuration 3-4, 3-5
Catalyst 2955 (continued)
displaying Catalyst 2955 switch alarms
3-12
enabling SNMP traps 3-12
FCS error hysteresis threshold 3-2
global status monitoring alarms
power supply alarm
3-2
temperature alarm 3-2
port status monitoring alarms
FCS bit error rate alarm
3-3
link fault alarm 3-3
port is not operating alarm 3-3
port not forwarding alarm 3-3
triggering alarm options
configurable relays
3-4
FCS Bit Error Rate alarm 3-3
methods to trigger 3-4
SNMP traps 3-4
syslog messages 3-4
cautions xxiv
CC (command switch) 7-24
CDP
and trusted boundary
27-21
automatic discovery in switch clusters 7-6
configuring 21-2
default configuration 21-2
described 21-1
disabling for routing device 21-3, 21-4
enabling and disabling
on an interface
21-4
on a switch 21-3
monitoring 21-5
overview 21-1
transmission timer and holdtime, setting 21-2
updates 21-2
CGMP, joining multicast group 18-2
Cisco Access Analog Trunk Gateway 1-14
Cisco CallManager software 1-13, 1-14