Specifications

7-23
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-07
Chapter 7 Clustering Switches
Creating a Switch Cluster
Figure 7-12 Using the Topology View to Add Member Switches
Creating a Cluster Standby Group
The cluster standby group members must meet the requirements described in the “Standby Command
Switch Characteristics” section on page 7-3 and “HSRP and Standby Command Switches” section on
page 7-12. To create a cluster standby group, select Cluster > Standby Command Switches
(Figure 7-13).
Instead of using CMS to add switches to a standby group and to bind the standby group to a cluster, you
can use the standby ip, the standby name, and the standby priority interface configuration commands
and the cluster standby group global configuration command.
Thin line means a
connection to a
candidate switch.
Right-click a candidate
switch to display the
pop-up menu, and select
Add to Cluster to add
the switch to the cluster.
65725