Specifications

2-53
Catalyst 2950 and Catalyst 2955 Switch Command Reference
78-15304-01
Chapter 2 Cisco IOS Commands
dot1x default
dot1x default
Use the dot1x default global configuration command to reset the global 802.1X parameters to their
default values.
dot1x default
Syntax Description This command has no arguments or keywords.
Defaults This command has no default setting.
Command Modes Global configuration
Command History
Examples This example shows how to reset the global 802.1X parameters:
Switch(config)# dot1x default
You can verify your settings by entering the show dot1x privileged EXEC command.
Related Commands
Release Modification
12.1(6)EA2 This command was first introduced.
Command Description
dot1x max-req Sets the maximum number of times that the switch sends an Extensible
Authentication Protocol (EAP)-request/identity frame before restarting the
authentication process.
dot1x
re-authentication
Enables periodic re-authentication of the client.
dot1x timeout
quiet-period
Sets the number of seconds that the switch remains in the quiet state
following a failed authentication exchange.
dot1x timeout
re-authperiod
Sets the number of seconds between re-authentication attempts.
dot1x timeout
tx-period
Sets the number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before retransmitting the request.
show dot1x Displays the 802.1X statistics, administrative status, and operational status
for the switch or for the specified interface.