Specifications

2-151
Catalyst 2950 and Catalyst 2955 Switch Command Reference
78-15304-01
Chapter 2 Cisco IOS Commands
show auto qos
show auto qos
Use the show auto qos user EXEC command to display the automatic quality of service (auto-QoS)
configuration that is applied.
show auto qos [interface [interface-id]] [ | {begin | exclude | include} expression]
This command is available only if your switch is running the enhanced software image (EI).
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines The show auto qos [interface [interface-id]] command displays the auto-QoS configuration; it does not
display any user changes to the configuration that might be in effect.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
• show mls qos
• show mls qos map cos-dscp
• show mls qos interface
• show running-config
• show wrr-queue bandwidth
• show wrr-queue cos-map
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
interface [interface-id] (Optional) Display auto-QoS information for the specified
interface or for all interfaces. Valid interfaces include physical
ports.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified
expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(12c)EA1 This command was first introduced.