Specifications

2-93
Catalyst 2950 and Catalyst 2955 Switch Command Reference
78-15304-01
Chapter 2 Cisco IOS Commands
lacp system-priority
lacp system-priority
Use the lacp system-priority global configuration command to set the system priority for Link
Aggregration Control Procol (LACP). Use the no form of this command to reset the LACP system
priority.
lacp system-priority priority-value
no lacp system-priority
Syntax Description
Defaults The default priority value is 32768.
Command Modes Global configuration
Command History
Usage Guidelines Although this is a global configuration command, the priority only takes effect on EtherChannels that
have physical interfaces with LACP enabled.
Note For more information about configuring LACP on physical interfaces, refer to the “Configuring
Etherchannels” chapter in the software configuration guide for this release.
Examples This example shows set the system priority for LACP:
Switch(config)# lacp system-priority 32764
You can verify your settings by entering the show lacp sys-id global configuration command.
Related Commands
priority-value System priority for LACP. The range is from 1 to 65535.
Release Modification
12.1(12c)EA1 This command was first introduced.
Command Description
lacp port-priority Sets the LACP priority for a specific port.