Specifications

2-92
Catalyst 2950 and Catalyst 2955 Switch Command Reference
78-15304-01
Chapter 2 Cisco IOS Commands
lacp port-priority
lacp port-priority
Use the lacp port-priority interface configuration command to set the port priority for Link
Aggregration Control Procol (LACP). Use the no form of this command to reset the LACP port priority.
lacp port-priority priority-value
no lacp port-priority
Syntax Description
Defaults The default priority value is 32768.
Command Modes Interface configuration
Command History
Usage Guidelines This command only takes effect on EtherChannel interfaces that are already configured for LACP.
Note For more information about configuring LACP on physical interfaces, refer to the “Configuring
EtherChannels” chapter in the software configuration guide for this release.
Examples This example shows set the port priority for LACP:
Switch(config)# lacp port-priority 32764
You can verify your settings by entering the show etherchannel privileged EXEC command.
Related Commands
priority-value Port priority for LACP. The range is from 1 to 65535.
Release Modification
12.1(12c)EA1 This command was first introduced.
Command Description
lacp system-priority Globally sets the LACP priority.