Specifications

3-5
Cisco IOS Telephony Service, Version 2.02
Chapter 3 Additional Configuration Tasks
Information About Additional Configuration Tasks
DETAILED STEPS
Configuring Three-Party G.711 Conference Calls
Cisco IOS Telephony Service supports three-party conference for local and on-net calls. To participate
in the conference, all conference participants must use G.711. This service also supports conversion
between G.711 u-law and a-law. The maximum number of simultaneous conferences is
platform-specific.
SUMMARY STEPS
1. telephony-service
2. max-conferences max-conference-numbers
Command Purpose
Step 1
Router(config)# telephony-service
Enters telephony-service configuration mode.
Step 2
Router(config-telephony-service)# timeouts
interdigit seconds
Configures the interdigit timeout value for all
Cisco IP phones attached to the router.
The interdigit timeout specifies the number of
seconds that the system waits after the caller has
entered the initial digit or a subsequent digit of the
dialed string. If the timeout ends before the
destination is identified, a tone sounds and the call
ends. This value is important when using
variable-length dial peer destination patterns (dial
plans). For more information on setting dial plans,
refer to the “Configuration Dial Plans, Dial Peers, and
Digit Manipulation” chapter of the Cisco IOS Voice,
Video, and Fax Configuration Guide, Release 12.2.
The seconds argument is the interdigit timeout wait
time in seconds. A valid entry is an integer from 2 to
120 seconds. The default is 10 seconds.